PARROT Gadgets

The battery is a 3 cells high grade Lithium-Polymer battery, with a capacity of 1,000 mAh at 11.1 volts and a discharge capacity of 10C. It includes a PCM (Protection Circuit Module) which protects the battery against over charge, over discharge and short circuits. The battery is protected by a rigid casing, and complies with UL2054 safety standards.It has two connectors: one discharge connector to provide current to the drone, and another smaller one for balance charging. The balance...

The double sided tape is a cunning way to help you repair the broken parts of the EPP (Expanded Polypropylene) elements of the drone (body set, indoor or outdoor hull) if you damage them.

Three types of screws are used in the AR.Drone. The one with the slices are used to attach the main board and the navigation board on the body set. The longer screws secure the motor's electronic controller to the central cross and the shorter screws secure the motor itself on the central cross.

The body set is manufactured in EPP, a very light and high resistance plastic.It carries the battery holder. The battery holder is mounted on the main body of the drone with foam that absorbs the motors vibrations. The battery is slightly shifted towards the rear of the device to keep the AR.Drone center of gravity the geometric center.This kit also includes screws and spacers required for installation of two electronic boards of the AR.Drone.The wide-angle frontal camera provides a panoramic...

The main board includes the Parrot P6 central CPU of the AR.Drone. The P6 chip has been specially designed for the AR.Drone. It includes a 468 MIPS ARM926EJ Risc CPU and a video accelerator. The main board runs Linux along with AR.Drone software. The main board includes 256 Mb 200 MHz 32 Bits MDDR RAM and 32Mb of NAND Flash. It includes a Wi-Fi chipset from Atheros and an USB Port for direct flashing and future extensions. The Atmel P6MU chip is a power management chipset for the P6...

The navigation board includes the sensors and a 40 MIPS microcontroller with a fast 12 bits ADC converter.The navigation board has one ultrasonic transceiver and one ultrasonic receiver to measure the height of the drone up to 6 meters / 20 feet. The altimeter provides a measure at a 25 Hz rate.A 3 axis digital MEMS accelerometer positioned at the center of gravity of the AR.Drone. The accelerometer is used in a +/- 2g range and digitalized by an on-chip 10 bit ADC. Data are sent to the...

Soar through the skies with this AR. Race Pylons & Finish Line for AR. Drone. This pack contains a finish line, two inflatable pylons, a carry bag and a set of patches.   The finish line is detected by the AR. Drone bottom camera, so you can time laps.

Soar through the skies with this AR. Race Donut for AR. Drone. This pack contains an inflatable donut, a carry bag and a set of patches. You can create your own circuits and challenge your friends. The double line inside the donut is detected by the AR. Drone bottom camera, so you can time laps and validate each pass through the donut.

This pack contains an outdoor hull, a transparent shell and a set of double adhesive tapes.This pack allows you to customize your AR.Drone by painting the interior of the shell and then sticking it to the blank hull with the adhesive tapes.Be creative and impress your friends with the unique style of your AR.Drone!Also learn about the sheets of AR.Drone official stickers to customize your AR.Drone even more.

This pack contains an indoor hull, a transparent shell and a set of double adhesive tapes.This pack allows you to customize your AR.Drone by painting the interior of the shell and then sticking it to the blank hull with the adhesive tapes.Be creative and impress your friends with the unique style of your AR.Drone!Also learn about the sheets of AR.Drone official stickers to customize your AR.Drone even more.